News:

Welcome to the Golf Club Atlas Discussion Group!

Each user is approved by the Golf Club Atlas editorial staff. For any new inquiries, please contact us.


John Connolly

  • Karma: +0/-0
Irrigation Ponds - What are the options?
« on: October 27, 2015, 06:40:29 PM »
Our course has an ancient buried metal tank for the irrigation system. It's off the course but on the property and it's getting up there in age. My understanding is that this is a rare bird. Are there any other experiences out there in dealing with an "end-of-life" underground reservoir tank? Time to find a spot for a new irrigation pond? Rebuild the in-ground metal tank?




"And yet - and yet, this New Road will some day be the Old Road, too."

                                                      Neil Munroe (1863-1930)

Anthony_Nysse

  • Karma: +0/-0
Re: Irrigation Ponds - What are the options?
« Reply #1 on: October 27, 2015, 07:32:37 PM »
Are you referring to a wet well?
Anthony J. Nysse
Director of Golf Courses & Grounds
Apogee Club
Hobe Sound, FL

Steve Lang

  • Karma: +0/-0
Re: Irrigation Ponds - What are the options?
« Reply #2 on: October 27, 2015, 08:09:03 PM »
 8)  John,


How large is this tank?  Are you sure its not just a small surge tank for the pumps to keep them from turning on and off too frequently and burning out the motors?
Inverness (Toledo, OH) cathedral clock inscription: "God measures men by what they are. Not what they in wealth possess.  That vibrant message chimes afar.
The voice of Inverness"

John Connolly

  • Karma: +0/-0
Re: Irrigation Ponds - What are the options?
« Reply #3 on: October 27, 2015, 08:19:41 PM »
Anthony,
I wish I knew what a "wet well" was.


Steve,
This is the one and only reservoir for our course. Huge underground capacity built with innumerable "catacombs" which draws from an adjacent well/water table. The "pump house" next to this underground tank distributes water to the irrigation system.



"And yet - and yet, this New Road will some day be the Old Road, too."

                                                      Neil Munroe (1863-1930)

Jeff_Brauer

  • Karma: +0/-0
Re: Irrigation Ponds - What are the options?
« Reply #4 on: October 28, 2015, 12:55:11 PM »
John,

A wet well is the large, usually round chamber that holds the long shafts of the vertical turbine pumps at the pump house/pump station.  It connects to the irrigation lake allowing the pumps to suck water in for pumping.

As to water tanks, they are making a comeback.  The theory is that lakes lose a lot of water to evaporation, and a tank doesn't so its a water conservation measure.  Here in TX, and most of the south, evaporation is about 0.2-0.25 or more per day. If you have a two acre lake, that is about 10,000 Gallons a day, maybe 3 million gallons a year.  It was never considered a big deal, although we never sized lakes bigger than we needed for about 7 days storage (just in case water supply was turned off) but these days, they are looking for every way possible to save water.

Obviously, capacity is an issue, but it sounds like you have a relatively small course irrigation need if the old tank worked.  If you rebuilt with a new, probably some dug in and some above ground, you would be very trendy and environmentally conscious, and it might not cost a lot more than digging out your lake for more capacity. 
« Last Edit: October 28, 2015, 12:58:46 PM by Jeff_Brauer »
Jeff Brauer, ASGCA Director of Outreach

Greg Chambers

  • Karma: +0/-0
Re: Irrigation Ponds - What are the options?
« Reply #5 on: October 28, 2015, 01:10:17 PM »
Tanks aren't uncommon here in SoCal.  Some are above ground, some are below.
"It's good sportsmanship to not pick up lost golf balls while they are still rolling.”

PGertner

  • Karma: +0/-0
Re: Irrigation Ponds - What are the options?
« Reply #6 on: October 28, 2015, 02:00:15 PM »
Probably a ballast tank.

Steve Lang

  • Karma: +0/-0
Re: Irrigation Ponds - What are the options?
« Reply #7 on: October 28, 2015, 08:49:29 PM »
 8)  Might want to re-use the old tank bones and use spray on coating to rehabilitate, or even go to full high density polyethylene (HDPE) plastic liner, like 30 mils thick - heat fusion welded seams ... probably biggest issue is status of roof...
Inverness (Toledo, OH) cathedral clock inscription: "God measures men by what they are. Not what they in wealth possess.  That vibrant message chimes afar.
The voice of Inverness"

John Connolly

  • Karma: +0/-0
Re: Irrigation Ponds - What are the options?
« Reply #8 on: October 29, 2015, 09:47:51 PM »
Thanks everybody for your suggestions - I found them all very helpful.
"And yet - and yet, this New Road will some day be the Old Road, too."

                                                      Neil Munroe (1863-1930)

Tags:
Tags:

An Error Has Occurred!

Call to undefined function theme_linktree()
Back